7/30/2023 0 Comments Nintendo switch board viewMaybe the Pro controller is different, need to buy one though. That means it would be extremely hard to spoof button presses for TAS and twitch-plays. They used the keypad scanner built-in inside the BCM20734 with 128KHz clock for reading the buttons. Nintendo maybe is trying to discourage people from doing funky things to the Joy-Con?Īlso, in a bizarre move, Nintendo didn't use the traditional "one side pulled-up other side to ground" way of reading buttons, instead they used a keypad configuration where buttons are arranged in rows and columns. There are no silkscreen marking component and test point numbers. The "JC" is for the 10-pin Joycon connector, see below for details. Joy-Con PCB Layout and test pointsįull-size PDF of Joy-Con pinouts, both left and right. Please take a look at the contributers list and appreciate their work. Please remember that the information in this repo is the work of a lot more people than just me. Please make a post in the issue section, contributors have been immensely helpful. I'm just going to dump all my discoveries here, and hopefully they would be useful to the Nintendo Switch community. My Nintendo Switch reverse engineering attempts
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |